Changing settings from the operator panel
- 127 -
Item
Factory
default
Description
DHCPv6 Disable Set to obtain the IPv6 address automatically. Set to disable
when you do not use the IPv6 address.
Automatic
setup (WPS)
WPS-PBC Executed when setting is done by pressing the WPS button
of the wireless LAN access point.
WPS-PIN Executed when the PIN code displayed on this machine is
registered with the wireless LAN access point.
Wireless
Network
Selection
xxxxxx
Displays the list of wireless LAN access points detected by
Manual
Setup
Sets the security of the wireless LAN function.
WPA
Encryption
Displays the WPA-PSK encryption type.
The setting is carried out automatically according to the
security settings. (Impossible to switch in this menu)
WPA Pre-
shared Key
Input the pre-shared key.
Displayed when [Security] is set to any other value than
Executes the changes to security settings.
Reconnects to the wireless LAN (infrastructure).
Wireless(AP Mode) Setting
Item
Factory
default
settings
Description
Enter Password ********** Input the password required to enter the Admin Setup
Enables/Disables wired (AP mode).
Automatic Setup (PushButton) If YES is selected, automatic connection can be started
with a push button.
If the connection has failed, the system goes back to the
home screen. If the connection is successful, [Wireless(AP
Mode) connection setting is completed/Close by the setting
Manual Setup Displays the SSID and password of this machine for
Connection Settings SSID OKI-Printer
name-Last 6
digits of the
Inputs a new one to change the SSID.
Inputs a new one to change the password.
IPv4 Address 192.168.110.
Input the IPv4 address.
Executes connection setup.
AP Mode User Setting Don't
Sets whether or not to disclose the AP mode information to
users other than the administrator.
To Next Page
Loading...
