Oki C650 - An Afterimage Printed on the Front Edge of the Paper Is Printed

Troubleshooting
- 372 -
Cause
Solution
Reference
Color balance is not adjusted. Press the scroll buttons on the operator panel several times
to select [Calibration], adjust density, or adjust the color
balance.
Adjusting the
density
manually(P.169
)
Adjusting the
color balance
(density)(P.169)
Color misregistration is not
corrected.
Open and close the front cover. Or, press the scroll buttons
on the operator panel several times to select [Calibration] -
[Adjust Registration].
Adjusting
registration
manually(P.168
)
An afterimage printed on the front edge of the paper is printed
Cause
Solution
Reference
If an afterimage is printed under
about 94 mm, the media weight
may not be set correctly.
Press the scroll buttons on the operator panel several times
to select the paper tray you are using from [Menus] - [Tray
Configuration], and set an appropriate value for [Media
Weight]. Or, change [Media Weight] to a thinner value than
the present value.
Setting paper
information on
the operator
panel(P.81)
If an afterimage is printed at an
interval of about 94 mm, the fuser
unit may be scratched or dirty.
Replace the fuser unit. Replacing the
fuser
unit(P.310)