Troubleshooting
- 328 -
Fuser Unit End Of Life. Replace
With A New Fuser Unit
Please See HELP For Details
354 The fuser unit has reached the end of its service life. Please
replace the fuser unit with a new one.
You can continue printing for a while by opening and closing
the front cover.
To replace the fuser unit, see "Replacing the fuser unit(P.310)".
Belt Unit End Of Life. Replace With
A New Belt Unit
Please See HELP For Details
355 The belt unit has reached the end of its service life. Please
replace the belt unit with a new one.
You can continue printing for a while by opening and closing
the front cover.
To replace the belt unit, see "Replacing the belt unit(P.308)".
Belt Unit End Of Life. Replace With
A New Belt Unit
Please See HELP For Details
356 The waste toner area of the belt unit is full. Please replace the
belt unit with a new one.
To replace the belt unit, see "Replacing the belt unit(P.308)".
Waste Toner Full. Install New
Waste Toner Box
Please See HELP For Details
357 See "Replacing the black(K) toner cartridge and the waste
toner box(P.298)".
Waste Toner Transfer Error.
Please Reset Waste Toner Box
Please See HELP For Details
359 See "Replacing the black(K) toner cartridge and the waste
toner box(P.298)".
Paper Size Error. Reset Paper In
Tray Name
Please See HELP For Details
400 Multiple sheets of paper are fed at a time from the displayed
tray. Or, the paper of a size different from the paper size setting
of the tray is fed.
Remove the jammed paper.
Remove the paper temporarily from the tray when multiple
sheets of paper are fed at a time. Shuffle the paper well,
horizontally align the edge of paper, and load the paper in the
tray again.
Otherwise, check the size of paper to print on and the paper
size setting of the tray, and match the paper settings.
Multiple Sheets Of Paper Have
Been Fed. Reset Paper In Tray
Name
Please See HELP For Details
401 Multiple sheets of paper are fed at a time from the displayed
tray. Or, the paper of a size different from the paper size setting
of the tray is fed.
Remove the jammed paper.
Remove the paper temporarily from the tray when multiple
sheets of paper are fed at a time. Shuffle the paper well,
horizontally align the edge of paper, and load the paper in the
tray again.
If overlapping paper is not fed, check the size of the paper to
print on and the paper size setting of the tray, and match the
Printing Stopped Because The
Rear Output Tray Is Opened
During The Printing Job. Please
Remove Paper
Please See HELP For Details
409 Open the front cover, and remove the paper left in the machine
if any. Then, close the front cover.
Rear Output Tray Open. Duplex
Not Available
Please See HELP For Details
581 Please close the rear output tray.
Color Name Toner Is Empty
Replace With A New Toner
Cartridge. Please See HELP For
Details
410, 411, 412 The toner of the displayed color is empty.
You can continue using the device for a while by opening and
closing the front cover, but the image drum may be damaged.
Therefore, please replace the toner cartridge with a new one
promptly. To replace the toner cartridge, see "Replacing the
toner cartridge (C/M/Y)(P.301)".
410: Yellow; 411: Magenta; 412: Cyan