Oki C650 - Page 46

Connecting to the PC after preparing the device
- 46 -
 Connecting with WPS
 Connecting by selecting a wireless LAN access point from the operator panel
 Connecting by setting manually from the operator panel
 When you connect with wireless LAN by WPA/WPA2-EAP, see "Setting IEEE802.1X (Wireless LAN)(P.212)".
Connecting with WPS
If the wireless LAN access point supports WPS, you can easily connect to the wireless LAN using the push
button for easy setup (WPS button).
1 Check the position of push button for easy setup (WPS button) and the time for which the
button is pressed in the User's Manual enclosed with the wireless LAN access point.
2 Check that the wireless LAN access point is activated and operating properly.
3 Press the scroll button ▲ on the operator panel several times to select [Wireless(Infrastructure)
Setting], and press «OK».
4 Input the admin password using the numeric keypad, and press «OK».
Admin password(P.194)
"It is not possible to use the wireless(AP Mode) at the same time." will be displayed for about 5 seconds.
5 Press ▲ to select [Enable], and press «OK».
6 Press ▼ several times to select [Automatic setup (WPS)], and press «OK».
7 Check that [WPS-PBC] is selected, and press «OK».
8 When "Implementing this method? Pushbutton method" is displayed, check that [Yes] is
selected, and press «OK».