Omron 3G3RX - Page 438

App-43
Appendix-1 Parameter List
Appendix
Options
P033
Torque reference
input selection
[TRQ cmd source]
00: O (Terminal O)
01: OI (Terminal OI)
02: O2 (Terminal O2)
03: OPE (Digital Operator)
06: Option 1
07: Option 2
00 No 
4-126
P034
Torque reference
setting
[TRQ cmd setting]
0 to 200 (0.4 to 55 kW)
0 to 180 (75 to 132 kW)
0Yes%
P035
Polarity selection at
torque reference via
O2
[O2 TRQ polarity]
00: Sign (Signed)
01: Direction (Depends on the RUN direction)
00 No 
P036
Torque bias mode
[TRQ bias mode]
00: OFF (None)
01: OPE (Digital Operator)
02: O2 (Terminal O2)
05: Option 1
06: Option 2
00 No 
4-126
4-127
P037
Torque bias value
[TRQ bias value]
-200 to 200 (0.4 to 55 kW)
-180 to 180 (75 to 132 kW)
0Yes%
P038
Torque bias polarity
selection
[TRQ bias polarity]
00: Sign (Signed)
01: Direction (Depends on the RUN direction)
00 No 
P039
Speed limit value in
torque control
(forward)
[TRQ SpeedLmt
(FW)]
0.00 to Maximum frequency 0.00 Yes Hz
4-126
P040
Speed limit value in
torque control
(reverse)
[TRQ SpeedLmt
(RV)]
0.00 to Maximum frequency 0.00 Yes Hz
P044
DeviceNet comm
Watch dog timer
[DeviceNet comm
WDT]
0.00 to 99.99 1.00 No s 
P045
Operation setting at
communications error
[Act. Network com
loss]
00: Trip
01: Decel-Trip (Trip after deceleration stop)
02: Ignore
03: Free RUN
04: Decel-Stop (Deceleration stop)
00 No 
P046
Instance Number
[Instance No.]
0: Basic speed I/O
1: Extended speed I/O
2: Extended speed and Torque control
3: Special I/O
4: Extended control I/O
5: Extended control I/O and multifunction I/O
monitor
6: Flexible format
7: Extended speed and Acceleration control
8-20: Not used
1No
Parameter
No.
Function name Monitor or data range
Default
setting
Changes
during
operation
Unit Page
* 2nd/3rd control is displayed when "SET(08)/SET3(17)" is allocated to one of multi-function inputs from C001
to C008.