Omron CJ2 CPU UNIT SOFTWARE User Manual

10-27
10 CPU Unit Functions
CJ2 CPU Unit Software User’s Manual
10-3 Startup Settings and
Maintenance
10
10-3-5 Automatic Transfer at Startup
Automatic transfer at startup is used to read the user program, parameters, and I/O memory data from
a Memory Card to the CPU Unit when the power is turned ON.
The files for automatic transfer at startup can be created in the Memory Card Window of the CX-Pro-
grammer and stored in the Memory Card.
This function cannot be used to read EM file memory.
Additional Information
I/O memory will be unstable if operation is performed without the battery, so this function can be
used to ensure that the correct values are always used.
There are two ways to perform automatic transfer at startup: transferring either with or without a param-
eter file (AUTOEXEC.STD). The file name to be created depends on which of the two transfer types is
used.
10-3-5 Automatic Transfer at Startup
Overview
Types of Automatic Transfer at Startup
Type of automatic transfer at
startup
File name Application
Transfer with parameter file AUTOEXEC or ATEXEC@@ Overwriting the program and network set-
tings
Transfer without parameter file REPLACE or REPLC@@ Overwriting the program
LAREHFIREP
ER
R/ALM
RUN
INH
COMM
BKUP
PRPHL
CONTROLLER
CPU64-EIP
CJ2H
SYSMAC
PROGRAMMABL
E
PORT
OPEN
BUS
Y
MC
PW
R
NS
MS
COMM
10 M
100M
CPU Unit
User program
Parameters
I/O memory
Files for automatic
transfer at startup
Memory Card
Batch reading

Omron CJ2 CPU UNIT SOFTWARE Specifications

General

Brand	Omron
Model	CJ2 CPU UNIT SOFTWARE
Category	Software
Language	English