Omron CJ2 CPU UNIT SOFTWARE User Manual

4 CPU Unit Initialization
4-4
CJ2 CPU Unit Software User’s Manual
Additional Information
Setting Program Tasks
The initial settings for assigning programs to tasks is set with the following program properties
using the CX-Programmer.
z PLC Name
This is a name that the user sets for the CPU Unit. Make the setting by selecting PLC Info − PLC
Info from the PLC Menu of the CX-Programmer.
The system will check if the name registered in the PLC matches the PLC name in the project when
the CX-Programmer is online.
z PLC Setup
The PLC Setup is used to make changes for using the CPU Unit with non-default specifications. The
following settings are examples of the defaults for the CPU Unit.
Startup mode: RUN mode
RS-232C port: Host link
Fixed servicing time: 10% of cycle time
To use specifications other than these defaults, change the PLC Setup using the CX-Programmer,
and transfer the PLC Setup to the CPU Unit.
⇒ Transferring PLC Setup from the CX-Programmer
PERIFHERAL
ERR/ALM
RU
N
IN
H
C
O
MM
BKUP
PRPH
L
C
ON
TROLLER
CPU
64-
EIP
CJ2H
SYSMAC
PROG
RAM
MABLE
PORT
O
P
EN
BUSY
MCPWR
N
S
MS
C
O
M
M
10M
100M
Transferring from the CX-Programmer
CPU Unit
PLC Setup
PLC Setup

Omron CJ2 CPU UNIT SOFTWARE Specifications

General

Brand	Omron
Model	CJ2 CPU UNIT SOFTWARE
Category	Software
Language	English