Appendices
A-128
CJ2 CPU Unit Software User’s Manual
A326 A326.05 Pulse Output 2
No-origin Flag
ON when the origin has not been determined for pulse output 2
and goes OFF when the origin has been determined.
OFF: Origin established, ON: Origin not established
Turned ON
when oper-
ation starts.
Turned
ON when
power is
turned
ON.
Refreshed each
cycle during over-
seeing process.
A326.06 Pulse Output 2
At-origin Flag
ON when the PV of pulse output 2 matches the origin (0).
OFF: Not stopped at origin, ON: Stopped at origin
Cleared Cleared Refreshed each
cycle during over-
seeing process.
A326.07 Pulse Output 2
Output Stopped
Error Flag
ON when an error occurred while outputting pulses in the pulse
output 2 origin search function. The Pulse Output 2 Output Stop
Error Code will be written to A438.
0: No error, ON: Stop error
Cleared Cleared • Cleared when an
origin search is
started.
• Refreshed when
a fatal pulse out-
put error occurs
during an origin
search.
• Refreshed when
the limit input sig-
nal for pulse out-
put is set to be
always enabled in
the PLC Setup
and pulse output
is stopped due to
the limit input.
• Cleared when
both limit inputs
are disabled and
a fatal pulse out-
put error code is
stored.
A326.08 Pulse Output 2
Interrupt Feed-
ing In-progress
Flag
These flags are turned ON when an interrupt input is received
after output from pulse outputs 2 to 3 is started with the
IFEED(892) instruction.
OFF: Interrupt feeding not in progress.
ON: Interrupt feeding in progress.
Cleared Cleared • Cleared during
overseeing pro-
cessing after
completing inter-
rupt feeding.
• Refreshed when
interrupt input is
received after
starting pulse out-
put with
IFEED(892)
instruction.
A326.09 Pulse Output 2
Interrupt Feed-
ing Error Flag
This flag will turn ON if an overflow or underflow occurs when an
interrupt input is received, or when the specified number of pulses
is moved, after output from pulse outputs 2 is started with the
IFEED(892) instruction.
OFF: Overflow/underflow or specified number of pulses has been
moved.
ON: No error.
Cleared Cleared • Cleared when
IFEED(892)
instruction pro-
cessing is
started.
• Turned ON if an
overflow or under-
flow occurs when
an interrupt input
is received, or if
an overflow or
underflow occurs
while the speci-
fied number of
pulses is being
moved, after
operation is
started with the
IFEED(892)
instruction with
the origin defined.
A327 A327.00 Pulse Output 3
Pulse Output
Status Flag
This flag will be ON when pulses are being output from pulse out-
put 3 according to an ORG(889), ACC(888), PLS2(887), or
IFEED(892) instruction and the output frequency is being
changed in steps (accelerating or decelerating).
OFF: Constant speed, ON: Accelerating/decelerating
Cleared Cleared Refreshed each
cycle during over-
seeing process.
Address
Name Function
Status
after mode
change
Status at
startup
Write timing/
Related flags, set-
tings
Words Bits
To Next Page
Loading...
