Omron NS - Page 240

Section 10 Transferring Data 10-1 Transferring Data to the PT
NS-Designer Operation Manual
Refer to 6-6-4 Setting Ethernet in the NS Series Setup Manual for details on making settings, such
as the IP Address, at the PT.
Reference
♦ With NS-Designer Ver. 2.X and earlier versions, data must be transferred via serial cable or Mem-
ory Card before transferring data via Ethernet. This is not necessary with Ver. 3.X or later versions.
R
R
e
e
f
f
e
e
r
r
e
e
n
n
c
c
e
e
10-4