143
Line Graphs Section 7-10
5. Make the line settings for the line graph.
Note Data is read from the words that start with the specified address for the speci-
fied number of display points. When the data format is 1 word, data is read in
blocks of one times the number of display points. For 2-word data, reading is
done in blocks of two times the number of display points.
6. Check the Base Screen
7. Transfer the screen to the PT.
8. Check operation.
Set appropriate values for D100 to D179, and check the operation. To update
the graph, turn ON W20.00 (bit 00 of W20).
To stop updating the graph, turn OFF W20.00 (bit 00 of W20).
Do not change the Reverse/
Blink settings for this sample.
Address: D100
To Next Page
Loading...
