Omron OMNUC G Series User Manual

5-55
5-26 User Parameters
Operating Functions
5
5-26 User Parameters
Set and check the user parameters in Parameter Setting Mode.
Fully understand what the parameters mean and the setting procedures, and set the parameters
according to the system.
Some parameters are enabled by turning the power OFF and then ON again. After changing these
parameters, turn OFF the power, confirm that the power indicator has gone OFF, and then turn ON
the power again.
Setting and Checking Parameters
 Overview
Use the following procedure to set or check parameters.
Go to Parameter Setting Mode. Press the key, and then press the key once.
Select the Parameter Type --- ,
Switch to the Parameter Setting Display ---
Set the parameter number (Pn) --- ,
Display the parameter setting ---
Change the parameter setting --- , ,
Save the changed setting to memory and return to Parameter Setting Mode ---
 Operating Procedures for 16-bit Positioning Parameters
1. Displaying Parameter Setting Mode
2. Selecting the Parameter Type
Key
operation
Display example Explanation
The default display is displayed.
Press the key to display Monitor Mode.
Press the key to display Parameter Setting Mode.
Key
operation
Display example Explanation
Confirm that 16-bit Parameter is selected.
Uknk_k5kpkd
1k6kbkiktkp
1k6kbkiktkp

Omron OMNUC G Series Specifications

General

Brand	Omron
Model	OMNUC G Series
Category	Servo Drives
Language	English