Omron OMNUC G Series - Chapter 6 Operation

Chapter 6
Operation
6-1 Operational Procedure ....................................... 6-1
6-2 Preparing for Operation...................................... 6-2
Items to Check Before Turning ON the Power......................6-2
Turning ON Power ................................................................6-4
Checking the Displays ..........................................................6-5
Absolute Encoder Setup .......................................................6-6
6-3 Using the Parameter Unit................................... 6-8
Names of Parts and Functions..............................................6-8
6-4 Setting the Mode ................................................ 6-9
Changing the Mode...............................................................6-9
Monitor Mode ........................................................................6-10
Parameter Setting Mode .......................................................6-17
Parameter Write Mode..........................................................6-23
Normal Mode Autotuning ......................................................6-24
Auxiliary Function Mode........................................................6-25
Copy Mode............................................................................6-28
6-5 Trial Operation ................................................... 6-31
Preparation for Trial Operation .............................................6-31
Trial Operation with CX-Drive ...............................................6-31