Verify the Rear I/O Module
Servicing the Rear I/O Module 179
■
Started the system.
See “Power On the Server (Oracle ILOM)” on page 192.
2.
Verify that the System Service Required LED on the rear I/O module is not lit.
See “Rear Panel Controls and LEDs” on page 33.
3.
Log in to Oracle ILOM.
See “Log In to Oracle ILOM (Service)” on page 28.
4.
Start the faultmgmt shell.
-> start SP/faultmgmt/shell
Are you sure you want to start the faultmgmt shell (y/n)? y
faultmgmtsp>
5.
Use the fmadm faulty command to determine if the server is operating normally.
■
If a fault was detected, see “Diagnostics Process” on page 25.
■
If no fault was detected, the rear I/O module was installed successfully.
Related Information
■
“Determine if the Rear I/O Module Is Faulty” on page 173
■
“Remove the Rear I/O Module” on page 174
■
“Install the Rear I/O Module” on page 176
To Next Page
Loading...
Need help?
General