Remove a Processor Module or Processor Filler Module
66 SPARC T5-8 Server Service Manual • November 2015
a.
Press down on the green button at the top of the cover to disengage the
cover from the processor module or modules.
b.
Keeping the button pressed down, push the cover toward the rear of the
processor module, and lift the cover up and away from the processor
module.
9.
Determine your next step:
■
If you are replacing DIMMs, see “Servicing DIMMs”.
■
If you are installing new processor modules to upgrade the server, return to
“Server Upgrade Process” on page 59.
■
If you are replacing a faulty processor module, follow these steps:
a.
Remove all of the DIMMs from the faulty processor module, and set
them in a safe place.
See “Remove a DIMM or DIMM Filler Panel” on page 76.
b.
Install the DIMMs into the new processor module.
See “Install a DIMM” on page 78.
c.
Install the processor module.
See “Install a Processor Module or Processor Filler Module” on page 67.
To Next Page
Loading...
Need help?
General