Panasonic MN103S

Chapter 9
16-bit Timer
Timer Output IX - 53
■ Setting Timer Output
Select “timer output” by the timer output waveform selection flag of the timer compare/capture mode register.
Timer pin polarity selection is the flag which sets the initial value of pin output. When it is set to “0”, the initial
value is “L” and when it is set to “1”, the initial value is “H”. The registers and flags that set output pins are
shown below.
Table:9.7.3 Selecting Timer Output Waveform and Timer Pin Polarity
TImer output waveform selection Timer pin polarity selection
TM8AIO TM8MDA(TMAO1-0) TM8MDA(TMAEG)
TM8BIO TM8MDB(TMBO1-0) TM8MDB(TMBEG)
TM9AIO TM9MDA(TMAO1-0) TM9MDA(TMAEG)
TM9BIO TM9MDB(TMBO1-0) TM9MDB(TMBEG)
TM10AIO TM10MDA(TMAO1-0) TM10MDA(TMAEG)
TM10BIO TM10MDB(TMBO1-0) TM10MDB(TMBEG)
TM11IO0 TM11MDA(TMAO1-0) TM11MDA(TMAEG)
TM11IO1 TM11MDA(TMAO1-0) TM11MDA(TMAEG)