Panasonic MN103S - Page 549

Record of Changes - 12
9-67 Table
Setup
Proce-
dure (2)
Change Set the count cycle
TM8CA(0x0000A208)=0x4E1F
Set the count cycle
TM8CA(0x0000A208)=0x752F
Descrip-
tion(2)
Change ⋅⋅⋅ Due to 20000 counts, the setting
value is 19999 (0x4E1F)
.
⋅⋅⋅ Due to 30000
counts, the setting
value is 29999 (0x752F)
.
9-70 Table
Setup
Proce-
dure (2)
Change Set the repeating cycle
TM8CA(0x0000A208)=0x4E1F
Set the repeating cycle
TM8CA(0x0000A208)=0x752F
Descrip-
tion(2)
Change ⋅⋅⋅ The setting value is 19999 (0x4E1F)
due to 20000 counts.
⋅⋅⋅ The setting value is 29999 (0x752F)
due to 30000 counts.
13-3 Figure
13.1.1
Change
Page Section Definition Previous Edition (Ver.1) New Edition (Ver.1.1)
Reception
Start condition
Reception buffer
Transmission shift
Start condition
detection circuit
Transmission buffer
SC2DIR
SC2STE
SC2CMD
SC2
S
Read/Write
SC2RB
SC2TB
SWAP MSB<->LSB
Transmission
2
Reception
Start condition
Reception buffer
Transmission shift
Start condition
detection circuit
Transmission buffer
SC2DIR
SC2STE
SC2CMD
SC2
S
Read/Write
SC2RB
SC2TB
SWAP MSB<->LSB
Transmission