Pitney Bowes Epic v3.1 - Page 310

Attached Cards
l Cards must be attached with at least two glue lines to a carrier sheet.
l Cards should be centered on the carrier sheet in both side-to-side and lengthwise orientations.
l Carrier sheet must not exceed two times the length of the card. Requires application review.
Packaging
In general, packaging of enclosures should not result in curling, creasing, folding or otherwise damaging
of the edges of the enclosure.
Stacking
Enclosures should be packaged in a way that will hold stacks even on the edges – uneven stacking can
result in unacceptable edge curl.
Uneven stacking with offset edges can result in unacceptabe curl (see diagram).
Stacking with Offset Edges Results in Curled Edges
Banding
l Bands should be loose enough to prevent scoring or creasing the paper.
l Paper bands are preferred to rubber bands.
l Cardboard chips at the top and bottom of each banded stack greatly reduce the chance of
enclosure damage and allow for tighter bands to be used.
l Enclosures should be free of paper shards, excessive dust, and powder.
Air Supply Requirements
Each Rotary Feeder requires:
l Air Pressure: 70PSI (4.9 bar)
l Flow: 1.8 SCFM (51 l/min)
Specifications
Pitney Bowes Epic v3.1 (ZVE0) Operator Guide May, 2018 Page 303 of 328