l Folds must not result in the free ends being greater than .25" (6mm) from a fold (see diagram).
Free Ends at 1/4-inch (6 mm) Maximum
l Short folds that result in either the leading or trailing edge being one and one half times as thick or
thicker than the opposite edge are not allowed (see diagram).
Ink and Surface Condition
l Ink should be dry or set sufficiently to prevent enclosures from sticking together (blocking).
l Ink should not smudge when enclosures are rubbed together.
l Powder should not be used to prevent enclosures from sticking together (blocking).
Envelopes (BRE)
l All types of envelopes are allowed. Overall thickness may not be more that 50% greater in the
center than at the leading edge (i.e. if leading edge is two paper thicknesses, center can not be
more that three thickness).
l Die cut envelope must be fed with window down, flap leading.
Die Cuts
l Die cut holes with and without windows are allowed as long as there is an area under the hole that
is not die cut.
l Die cut pressure sensitive labels with a backing sheet are allowed.
l Die cut labels without a backing sheet (such as remoistenable adhesive “stickers”) are not allowed.
Glue
l Any enclosure with glued features must not allow stray glue to attach enclosures together.
l Exposed “remoistenable” adhesive is not allowed.
Specifications
Pitney Bowes Epic v3.1 (ZVE0) Operator Guide May, 2018 Page 302 of 328
To Next Page
Loading...