Planmeca Compact I - Page 5

Planmeca Compact i Dental Unit TOC - 3
TABLE OF CONTENTS
Technical Manual
10 CLEAN WATER SYSTEM..............................................................E-5
11 WATER MANAGEMENT SYSTEM (WMS)....................................E-6
11.1 Changing the water filter (00271003)..........................................................E-8
Chapter F ADJUSTMENTS
1 MECHANICAL ADJUSTMENTS ....................................................F-1
1.1 Adjusting vertical position of the OP delivery arm column .......................... F-1
1.2 Adjusting friction of the OP delivery arm joints ........................................... F-2
1.3 Adjusting balance of the OP delivery arm................................................... F-3
1.4 Adjusting angle of the OP delivery arm instrument console ....................... F-9
1.5 Adjusting the side delivery arm base joint friction..................................... F-10
1.6 Adjusting the friction of the side delivery arm joint.................................... F-10
1.7 Adjusting the side delivery arm instrument console friction ...................... F-11
1.8 Adjusting the lifting friction of the side delivery arm.................................. F-11
1.9 Adjusting the tension of the side delivery arm gas spring......................... F-13
1.10 Adjusting friction of the ergo suction arm.................................................. F-15
1.11 Adjusting friction of the adjustable suction arm......................................... F-15
1.12 Removing play of the lifting adapter.......................................................... F-16
1.13 Adjusting the instrument arms .................................................................. F-17
2 ELECTRICAL ADJUSTMENTS ...................................................F-18
2.1 Calibrating backrest motor position sensor............................................... F-18
2.2 Calibrating lift motor position sensor......................................................... F-20
2.3 Calibrating motorized headrest motor position sensor.............................. F-22
2.4 Rewiring mains voltage selection jumper.................................................. F-25
3 PNEUMATICAL ADJUSTMENTS ................................................F-26
3.1 Adjusting internal water & air pressures ................................................... F-26
3.2 Adjusting syringe water and air flow rates ................................................ F-27
3.3 Adjusting coolants to the instruments ....................................................... F-27
4 WATER MANAGEMENT SYSTEM: ADJUSTING
THE SENSORS ............................................................................F-28
4.1 Preparations before adjustment................................................................ F-28
4.2 Adjusting the lower sensor........................................................................ F-30
4.3 Adjusting the upper sensor ....................................................................... F-30
5 BLEEDING OF THE SPRAY WATER SYSTEM ..........................F-31
6 WMS OPERATION .......................................................................F-32
6.1 List of abbreviations.................................................................................. F-32
6.2 WMS operation, normal use ..................................................................... F-32
6.3 WMS operation, WCS use ........................................................................ F-35