Polaris General 2020 User Manual

11.80
9850067 R01 - 2020-2021 GENERAL / GENERAL XP Service Manual
© Copyright Polaris Inc.
7. Close the door slowly and guide the latch to the
striker.
NOTICE
The latch will click twice when fully locked.
8. While pushing the door upward and inward, tighten
the four 13mm door hinge fasteners
t
.
TORQUE
Door Hinge Fasteners:
27 lb-ft (37 Nm)
9. Check the front door gap on its leading edge.
NOTICE
If door gap adjustment is needed, make a small
adjustment to the striker pin vertical position and redo
steps 2,7, and 8.
10.Verify the door properly opens, closes, and locks.
11. Install plastic door panel covers.
REAR DOOR ALIGNMENT
1. Loosen 13mm hinge fasteners
q
.
2. Remove hinge fasteners and remove plastic
packaging clip.
3. Close door and guide door latch into striker.
4. Ensure the door is fully locked
BODY / FRAME

Polaris General 2020 Specifications

General

Brand	Polaris
Model	General 2020
Category	Offroad Vehicle
Language	English