4.33
ELECTRONIC FUEL INJECTION
4
9924096 - 2013 RANGER RZR XP 900 / RZR XP 4 900 Service Manual
© Copyright 2012 Polaris Sales Inc.
9. Carefully lift the fuel pump out of the fuel tank. As the
fuel pump assembly is being removed, be aware of
float arm and pump pre-filter. Hold the float arm to the
pump body as you lift and tilt the pump to ensure that
the float arm is not bent when removed from the tank.
10. Transfer old fuel pump to a suitable container capable
of safely holding fuel. The fuel pump will retain some
fuel.
11. Inspect the inside of the fuel tank for debris (may
require flashlight and mirror). If debris like mud or sand
is present, fuel tank should be flushed and cleaned out
prior to installation of new fuel pump assembly.
IMPORTANT: It is recommended to remove the fuel
tank from the vehicle and rinse it with a small amount
of clean fuel. Do not use water or any other chemicals
to remove debris.
12. Remove new fuel pump assembly, gasket and PFA
nut from packaging. Use care not to bend float arm
during un-packaging. Do not lift or carry fuel pump
assembly by the float arm.
13. Use cleaning wipes provided to clean fuel tank
surface and threads. Remove all debris, grease and
oil. Allow surfaces to dry completely.
14. Install new PFA gasket onto fuel pump assembly
using care not to damage gasket or bend float arm.
To Next Page
Loading...
Need help?
General
