9.26
BRAKES
9924096 - 2013 RANGER RZR XP 900 / RZR XP 4 900 Service Manual
© Copyright 2012 Polaris Sales Inc.
REAR BRAKE PADS (RZR XP 4)
Pad Removal
1. Elevate and support rear of vehicle.
2. Remove the rear wheel.
3. Loosen pad adjuster screw 2-3 turns.
4. Remove the lower radius rod outer mounting bolt, nut
and washer from the bearing carrier. Swing radius rod
down. Discard the nut.
5. Remove the two caliper mounting bolts and lift caliper
off the brake disc.
NOTE: When removing caliper, be careful not to
damage brake line. Support caliper to avoid kinking
or bending brake line.
6. Push caliper piston into the caliper bore slowly using
a C-clamp or locking pliers with pads installed.
NOTE: Brake fluid will be forced through
compensating port into master cylinder fluid
reservoir when piston is pushed back into caliper.
Remove excess fluid from reservoir as required.
Use care when supporting vehicle so that it
does not tip or fall.
Severe injury may occur if machine tips or falls.
To Next Page
Loading...
