Polaris xp 2013 eps - Page 80

3.22
ENGINE / COOLING
9924096 - 2013 RANGER RZR XP 900 / RZR XP 4 900 Service Manual
© Copyright 2012 Polaris Sales Inc.
15. Rotate water pump shaft after seal installation to verify
free movement.
16. Place impeller onto the water pump shaft.
17. Apply Loctite
®
204
™
to the threads of the impeller bolt.
Install washer and impeller bolt and torque to
specification.
18. Clean cover (A) and housing gasket surfaces (B).
19. Install a new water pump cover gasket (C).
20. Install the water pump cover and (3) retaining bolts.
Torque bolts in sequence to specification.
21. Install (2) new water pump (O-rings) and lubricate
them with fresh engine oil.
22. Install water pump assembly into engine as shown in
the “Water Pump Installation” procedure.
= T
Water Pump Impeller Bolt:
89 ± 18 in-lbs (10 ± 2 Nm)
(Apply Loctite
®
204
™
to bolt threads)
ABC
= T
Water Pump Cover Bolts:
89 ± 18 in-lbs (10 ± 2 Nm)
(Apply Loctite
®
204
™
to bolt threads)
1
2
3
PU-50564
Bolt (LH Thread)
Impeller
Washer
Mechanical
Seal
Oil Seal
O-Rings
Water Pump Housing
Washers
Water Pump
Shaft
Drive Tab
Loctite
®
204
™