quadient IN-360 - Page 38

2. Check or change the type of impression, if you are not in [Standard] mode.
Press to access the Build Impression screen:
The type of impression is indicated on line 2 of the screen.
To change the type of Meter Impression, select the Type line, press [OK] and then
select [Standard] in the Type of impression screen, and press [OK].
To select an option in the screen:
- Highlight the option using the arrow keys and
- Then press to validate your selection.
3
Processing Mail
33
| Page 33 | Jan-13-2017 10:32 |