2. Insert the envelope into the mail path against the rear-guide wall, with the side to be
printed facing upwards.
If you want to seal the envelope, first engage the flap into the
moistener (if installed). Do not try to moisten self-adhesive
envelopes.
If a mail piece is bigger than mail path maximum thickness, you
may use a label tape.To know the maximum thickness, see Mail
Specifications on page 207
3. The Mailing System applies postage and the envelope is ejected.
3
Processing Mail
39
| Page 39 | Jan-13-2017 10:32 |
To Next Page
Loading...
Need help?
General
