1.
Press and enter the number of labels.
Make sure the labels are available in the label dispenser (see Filling the Label
Dispenser on page 101).
2.
Press to print the labels.
In optional mode Differential weighing ( )
From the home screen:
1. Place the stack of mail you want to process on the weighing platform, and then
follow the instructions on the screen or the steps below.
2. Remove the first mail piece from the top of the stack. The Mailing System displays
weight and postage on the home screen and starts motors automatically.
3. To print the imprint, insert the mail piece into the base against the rear-guide wall,
side to be printed facing upwards.
If mail piece is bigger than mail path maximum thickness (see Mail Specifications
on page 367), press before you press to print a label. The label is printed
at once.
4. The Mailing System applies postage and the mail piece (or label) is sent to the
catch tray.
When using sealer, collect the mail piece stack in the catch tray
and put stack aside to let envelopes dry.
62
| Page 62 | Jun-22-2021 11:01 |
3
Processing Mail
To Next Page
Loading...
