R&S ZNA67 - Page 536

GUI reference
R&S
®
ZNA
536User Manual 1178.6462.02 ─ 20
Harmonic Orders to Calibrate
If a harmonics measurement is active in the current channel, this section allows you to
specify the harmonic orders to be calibrated in the current channel.
By default, the firmware selects all harmonic orders that are relevant for an existing
harmonics trace in this channel.
Remote command:
[SENSe<Ch>:]CORRection:ADVanced:HARMonic:ORDer?
[SENSe<Ch>:]CORRection:ADVanced:HARMonic:ORDer:ADD
[SENSe<Ch>:]CORRection:ADVanced:HARMonic:ORDer:REMove
Cal softtool