Section 3. Systems Overview Model 8210/8250 Maintenance Manual
Operator Display and Programming
3-14 Publication: 1146945/001, Revised: 25 Sep 2018
41 Click-to-
Creep
0 to 4 1 1 Enables creep travel with the tiller arm
in the fully raised or lowered position.
0: Disable
1: Approximately 0.5 MPH
2: Approximately 1 MPH
3: Approximately 1.5 MPH
4: Approximately 2 MPH
Activate click-to-creep by pressing the
turtle button on the control head with
the tiller in the brake position. “SLO”
blinks on the display when in
click-to-creep mode.
Deactivate by pressing the turtle button
again. Also, the mode deactivates
automatically after 10 seconds or
immediately if the emergency reverse
(belly button) switch is pushed.
42 Not used
43 Not used
44 Reset Voltage Volts 23.16 to
25.20
0.01 24.84 Changing this value will automatically
change the “Full Volts” voltage.
The Reset voltage will always be greater
than the “Full Volts” voltage by at least
0.24 volts.
Model 8250: This setting has no effect
with the CAN based lithium-ion battery.
45 Not used
46 CAN Enabled
HF Charger
0 to 2 1 0 Enables CAN communication for Delta-Q
charger with charger profile selection.
0 = Disabled (default)
1 = Discover AGM Profile
2 = Trojan Wet Cell Profile
47 Not used
48 Not used
49 Alternate
Default
Selection
0 to 1 1 0 Provides a separate profile with custom
default settings for seven specific
parameters.
Model 8250: This setting has no effect
with the CAN based lithium-ion battery.
56 Alternate
Energy Source
0 to 2 1 0 Only setting 2 will be allowed while the
lithium-ion battery is connected to the
truck via CAN.
0 = Disabled (default)
1 = Fuel Cell (Not Available)
2 = Lithium-ion Battery
60 Not Used
Parameter Name Unit Range Step Default Description
Property of American Airlines
To Next Page
Loading...