Renesas HD6417641 - Figure 13.2 DMA Transfer Flowchart

Section 13 Direct Memory Access Controller (DMAC)
Rev. 4.00 Sep. 14, 2005 Page 425 of 982
REJ09B0023-0400
Figure 13.2 is a flowchart of this procedure.
Normal end
NMIF = 1
or AE = 1 or DE = 0
or DME = 0?
Bus mode,
transfer request mode,
DREQ detection selection
system
Initial settings
(SAR, DAR, DMATCR, CHCR,
DMAOR, DMARS)
Transfer (1 transfer unit);
DMATCR – 1 → DMATCR, SAR and
DAR updated
DEI interrupt request (when IE = 1)
TE = 1
No
Yes
No
Yes
No
Yes
Yes
No
Yes
No
*
3
*
2
Start
Transfer aborted
DMATCR = 0?
Transfer request
occurs?*
1
DE, DME = 1 and
NMIF, AE, TE = 0?
NMIF = 1
or AE = 1 or DE = 0
or DME = 0?
Transfer end
Notes: 1. In auto-request mode, transfer begins when NMIF and TE are all 0 and the DE and DME bits are
set to 1.
2. DREQ = level detection in burst mode (external request) or cycle-steal mode.
3. DREQ = edge detection in burst mode (external request), or auto-request mode in burst mode.
Figure 13.2 DMA Transfer Flowchart