Printer Features Parameters
33
3
âť–
âť–âť–
âť– Edge-Edge Print
Select this to maximize the printa-
ble area by minimizing the white
space along the edges, to approxi-
mately 0.04 inches (1 mm).
• Off
• On
Note
âť’ Default: Off
âť–
âť–âť–
âť– Default Printer Lang.
You can set the default printer lan-
guage if the machine cannot find
the printer language automatical-
ly.
• PCL
• PS
Note
âť’ Default: PCL
âť’ [Default Printer Lang.] appears if
the optional PostScript 3 unit is
installed.
Host Interface
âť–
âť–âť–
âť– I/O Buffer
You can set the size of the I/O
Buffer. Normally it is not neces-
sary to change this setting.
• 128 KB
• 256 KB
• 512 KB
Note
âť’ Default: 128 KB
âť–
âť–âť–
âť– I/O Timeout
You can set how many seconds the
machine should wait before end-
ing a print job. If data from another
port usually arrives in the middle
of a print job, you should increase
this timeout period.
• 10 seconds
• 15 seconds
• 20 seconds
• 25 seconds
• 60 seconds
Note
âť’ Default: 15 seconds
To Next Page
Loading...
Need help?
General
