Ricoh 2015 - System

Printer Features Parameters
31
3
System
❖
❖❖
❖ Print Error Report
Select this to have an error report
printed when a printer or memory
error occurs.
• On
• Off
Note
❒ Default: Off
❖
❖❖
❖ Auto Continue
You can select this to enable Auto
Continue. When it is On, printing
continues after a system error oc-
curs.
• Off
• 0 minutes
• 1 minute
• 5 minutes
• 10 minutes
• 15 minutes
Note
❒ Default: Off
❖
❖❖
❖ Memory Overflow
Select this to have a memory over-
flow error report printed.
• Not Print
• Error Report
Note
❒ Default: Not Print
❖
❖❖
❖ Memory Usage
You can select the amount of mem-
ory used in Font Priority or Frame
Priority, according to paper size or
resolution.
• Font Priority
This setting uses memory for
registering fonts.
• Frame Priority
This setting uses frame memory
for high speed printing.
Note
❒ Default: Frame Priority
❖
❖❖
❖ Duplex
You can select to have print on
both sides of each page.
• Off
• Long Edge Bind
• Short Edge Bind
Note
❒ Default: Off
❖
❖❖
❖ Copies
You can specify the number of
print sets. This setting is disabled if
the number of pages to print has
been specified with the printer
driver or another command.
• 1 to 999 by 1
Note
❒ Default: 1
❖
❖❖
❖ Edge Smoothing
Set this to enable Edge Smoothing.
• On
• Off
Note
❒ Default: On
❒ If Toner Saving is set to On,
Edge Smoothing is ignored
even if it is set to On.
❖
❖❖
❖ Toner Saving
Set this to enable Toner Saving.
• On
• Off
Note
❒ Default: Off