EasyManua.ls Logo

Ricoh 2015 - 2 Troubleshooting; Error & Status Messages on the Display

Ricoh 2015
814 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
11
2. Troubleshooting
Error & Status Messages on the Display
This section describes the principal messages that appear on the display. If a
message not described here appears, act according to the message.
Reference
Before turning the main power off, see Turning On the Power, Copy Refer-
ence.
Status messages
Message Status
Hex Dump Mode In Hex Dump mode, the machine prints received data in hexa-
decimal format. After printing, turn off the machine and then
back on again. Hex Dump mode is used for advanced trouble-
shooting.
Offline The machine is offline. To start printing, switch the machine
online by pressing {
{{
{Online}
}}
} on the control panel.
Please wait. Wait a while.
Printing... The machine is printing. Wait a while.
Ready This is the default ready message. The machine is ready for
use. No action is required.
Resetting job... The machine is resetting the print job. Wait until Ready ap-
pears on the display.
Setting change The machine settings are being changed. Wait a while.
Waiting... The machine is waiting for the next data to print. Wait a while.

Table of Contents

Related product manuals