Sending Fax Documents from Computers
63
5
LAN-Fax Operation Messages
Note
âť’ You can have the LAN-Fax Error Report printed when options are not prop-
erly selected, or there is a communication error with a computer. See p.80
“User Parameters” (switch 20, bit 0).
LAN-Fax Error Report
This report is printed when options are not properly selected, or a communica-
tion error with a computer occurs. Check the error message of the report.
If you entered a user code in the [Options] dialog box, this report can be sent to
you by e-mail, provided your e-mail address is programmed in the machine.
However, if User Code Management is on for fax, the report is not sent.
Note
âť’ You can select whether or not a LAN-Fax Error Report is printed. See p.80
“User Parameters” (switch 20, bit 0).
LAN-Fax Result by E-mail
If you entered a user code in the [Options] dialog box, the result can be sent to you
by e-mail, provided your e-mail address is programmed in the machine.
Note
âť’ You can select whether or not a LAN-Fax Result is sent to the specified e-mail
address. See p.80 “User Parameters” (switch 20, bit 7). If the message failed to
be sent to one or more of the specified destinations, the result is sent regard-
less of this setting.
Message Causes and Solutions
Cannot access the print-
er. Click [retry] to send
the data again.
Check the network connection.
Check that the power is turned on.
The number of destination
entries exceeds the lim-
it. Up to 300 entries can
be entered.
The number of destinations specified exceeds the maxi-
mum possible. The maximum number of destinations
that can be specified at one time is 300.
"LAN-Fax" has already
been launched. Cannot
launch it again.
The
[LAN-Fax]
dialog box is already open. Quit LAN-Fax
once, and then start it up again.
Failed to allocate memo-
ry.
Available memory on the computer is insufficient. Quit
applications currently not in use.
Kir-C2-AEcombine_F_FM.book Page 63 Monday, September 29, 2003 11:39 AM
To Next Page
Loading...
Need help?
General
