Ricoh Aficio 270 - Page 234

SERVICE PROGRAM MODE
A265/A267 4-48 SM
Mode No.
Class
1 and 2
Class
3
Function Settings
Inputs the fan control time for stand-by and
night mode.
1
Exhaust Fan Control
Timer
(Stand-by/Night
Mode)
The fan slows down after this time has
passed since the end of a job or enters
energy saver mode.
The fan stops after this time has passed
since any of the following conditions
occurred:
•
After entering night mode (fax/printer
installed)
•
After entering an SC condition.
30 ~ 120
1 s /step
30 s
Inputs the fan control timer for low power
mode.
5-906*
2
Exhaust Fan Control
Timer
(Low Power Mode)
The fan stops after this time has passed
since the machine entered low power mode.
0 ~ 180
1 s /step
180 s
Selects the brand name and the production
name for the Plug and Play function of
Windows 95/98.
These are registered in the NVRAM. If the
NVRAM is defective, these names should
be registered again.
5-907
Plug & Play Setting
Set this SP to 1. Then press down the
“Photo” key and the “OK” key or
(
key at
the same time to register the setting. If the
setting was successful, the beeper will
sound 5 times. If it failed, the beeper will
sound only twice.
If the setting is completed, a “
∗
“ mark will be
displayed before the selection.
Selects the paper size for the LCT.
5-908*
LCT Paper Size
Use this SP after changing the paper size in
the optional LCT (i.e., after changing the
side plate position for the LCT).
0: A4
(Eur./Asia
model)
1: LT
(American
model)
Selects whether or not the 24V supplies are
cut while night mode is active.
5-909*
24V Down Setting
(Night Mode)
Set this to ‘1’ if the customer wishes to
check the machine conditions displayed on
the operation panel LED (such as paper
end) while night mode is active.
0: 24V
down
1: 24V
supplied
5-911*
APS A4/LT
Sideways Priority
Specifies whether the machine selects LT
sideways or lengthwise paper if the original
is A4.
In inch models, if “Yes” is selected, LT
sideways or lengthwise is selected
automatically when the APS sensors detect
an A4 sideways or lengthwise original.
In mm models, if “Yes” is selected, A4
sideways or lengthwise is selected
automatically when the APS sensors detect
an LT sideways or lengthwise original.
0: No
1: Yes