BIT SWITCHES
SM 4-25 A265/A267
Service
Tables
A895
System Switch 11
No FUNCTION COMMENTS
4 Type of TTI used for
transmission using the ten-
key pad
0: TTI_1
1: TTI_2
1: The machine uses TTI_2 when the user dials
the destination using the ten-key pad. It is also
used for polling transmission and manual
transmission using the handset.
5-6
Not used Do not change the factory settings.
7 Use of parallel memory
transmission with G4
transmission
0: Disabled 1: Enabled
This determines whether parallel transmission
can be used with a G4 transmission or not.
Note that this bit is only effective if Parallel
Memory transmission is enabled (User Parameter
07 - bit 2).
System Switch 12
No FUNCTION COMMENTS
0
to
7
TTI/CIL printing position in the
main scan direction
CIL: Command Information
Line (Group 4)
TTI/CIL: 08 to 64 (BCD) mm
Input even numbers only.
This setting determines the print start position for
the TTI and CIL from the left edge of the paper. If
the TTI is moved too far to the right, it may
overwrite the file number which is on the top right
of the page. On an A4 page, if the CIL is moved
over by more than 60 mm, it may overwrite the
page number.
System Switch 13 - Not used (do not change the settings)
System Switch 14 - Not used (do not change the settings)
System Switch 15
No FUNCTION COMMENTS
0
Not used Do not change the settings.
1
Going into the Night mode
automatically
0: Enabled
1: Disabled
1: The machine will restart from the Energy Saver
mode quickly, because the +5V power supply is
active even in the Energy Saver mode.
2
Protocol dump data backup
0: Disabled
1: Enabled
1: The machine backs up the protocol dump data
for approximately one hour when the main switch
is turned off, in the same way as image data.
3-7
Not used Do not change the settings.
To Next Page
Loading...
