BIT SWITCHES
SM 4-47 A265/A267
Service
Tables
A895
Communication Switch 0C
No FUNCTION COMMENTS
0
to
4
Number of digits compared to
find the requester’s fax
number from the programmed
Quick/Speed Dials when
acting as a Transfer Station
00 - 1F (0 to 31 digits)
After the machine receives a transfer request, the
machine compares the own telephone number
sent from the Requesting Terminal with all
Quick/Speed Dials programmed in the machine,
starting from Quick Dial 01 to the end of the
Speed Dials.
This number determines how many digits from the
end of the telephone numbers the machine
compares.
If it is set to 00, the machine will send the report
to the first Quick/Speed Dial that the machine
compared. If Quick Dial 01 is programmed, the
machine will send the report to Quick 01. If Quick
Dial 01 through 04 are not programmed and
Quick Dial 05 is programmed, the machine will
send the report to Quick 05.
Default setting - 05(H) = 5 digits
5-7
Not used Do not change the settings.
Communication Switch 0D
No FUNCTION COMMENTS
0
to
7
The available memory
threshold, below which ringing
detection (and therefore
reception into memory) is
disabled
00 to FF (Hex), unit = 4 kbytes
(e.g., 06(H) = 24 kbytes)
One page is about 24 kbytes.
The machine refers to this setting before each fax
reception. If the amount of remaining memory is
below this threshold, the machine cannot receive
any fax messages.
If this setting is kept at 0, the machine will detect
ringing signals and go into receive mode even if
there is no memory available. This will result in
communication failure.
Communication Switch 0E
No FUNCTION COMMENTS
0
to
7
Minimum interval between
automatic dialing attempts
06 to FF (Hex), unit = 2 s
(e.g., 06(H) = 12 s)
This value is the minimum time that the machine
waits before it dials the next destination.
To Next Page
Loading...
