Ricoh Aficio 270 - Page 647

BIT SWITCHES
A265/A267 4-48 SM
Communication Switch 0F
No FUNCTION COMMENTS
0
to
7
Not used Do not change the settings.
Communication Switch 10
No FUNCTION COMMENTS
0
to
7
Memory transmission:
Maximum number of dialing
attempts to the same
destination
01 - FE (Hex) times
Communication Switch 11 - Not used (do not change the settings.)
Communication Switch 12
No FUNCTION COMMENTS
0
to
7
Memory transmission: Interval
between dialing attempts to
the same destination
01 - FF (Hex) minutes
Communication Switch 13 - Not used (do not change the settings.)
Communication Switch 14
No FUNCTION COMMENTS
0 Inch-to-mm conversion during
transmission
0: Disabled 1: Enabled
0: In immediate transmission, data scanned in
inch format are transmitted without conversion.
In memory transmission, data stored in the SAF
memory in mm format are transmitted without
conversion.
Note: When storing the scanned data into SAF
memory, the fax unit always converts the data
into mm format.
1: The machine converts the scanned data or
stored data in the SAF memory to the format
which was specified in the set-up protocol
(DIS/NSF) before transmission.
1-5
Not used Do not change the factory settings.