Ricoh Aficio 270 - Page 723

ERROR CODES
A265/A267 7-6 SM
Code Meaning Suggested Cause/Action
0-87
The control channel started
after an unsuccessful
primary channel.
• The receiving terminal restarted the control
channel because data reception in the primary
channel was not successful.
• This does not result in an error communication.
0-88
The line was disconnected
because PPR was
transmitted/received 9
(default) times within the
same ECM frame.
• Try using a lower data rate at the start.
• Try adjusting the cable equalizer setting.
2-10 The modem cannot enter
tx mode
• Replace the FCU.
2-11
Only one V.21 connection
flag was received
• Replace the FCU.
2-12 Modem clock irregularity
• Replace the FCU.
2-13 Modem initialization error
• Turn off the machine, then turn it back on.
• Update the modem ROM.
• Replace the FCU.
2-20 Abnormal coding/decoding
(cpu not ready)
• Replace the FCU.
2-23
JBIG compression or
reconstruction error
• Turn off the machine, then turn it back on.
• Replace the EXFUNC board if the error is
frequent.
2-24 JBIG ASIC error
• Turn off the machine, then turn it back on.
• Replace the EXFUNC board if the error is
frequent.
2-25
JBIG data reconstruction
error (BIH error)
2-26 JBIG data reconstruction
error (Float marker error)
2-27 JBIG data reconstruction
error (End marker error)
2-28
JBIG data reconstruction
error (Timeout)
• JBIG data error
• Check the sender’s JBIG function.
• Update the FCU ROM.
2-50 The machine resets itself
for a fatal FCU system
error
• If this is frequent, update the ROM, or replace
the FCU.
2-51 The machine resets itself
because of a fatal
communication error
• If this is frequent, update the ROM, or replace
the FCU.
3-00 G4 interface board reset
• Replace the G4 interface board or FCU.
3-10 Disconnection during ISDN
G3 communication
• Check the other terminal and the ISDN line.
• The other terminal may have dialed a wrong
number.
3-11 Disconnection during ISDN
G4 communication
• Check the other terminal and the ISDN line.
3-20
A CSA signal was received
during ISDN G4
communication
• The operator at the other terminal may have
interrupted the communication.