Default: [Off]
• On
• Off
Append CR to LF
Select whether or not to append a CR code to each LF code to print text data clearly.
Default: [Off]
• On
• Off
Resolution
You can specify the print resolution in dots per inch.
Default: [600dpi]
• 300dpi
• 600dpi
PS Menu
You can set conditions when using PostScript for printing.
Job Timeout
You can specify how long the printer waits (in seconds) before canceling the current job when
the job is interrupted while being processed. If you select Use Machine Setting(s), enter a value
between 0 to 999. (Default: 0)
Default: [Use Driver/Command]
• Use Driver/Command
• Use Machine Setting(s)
Wait Timeout
You can specify how long the printer waits (in seconds) before it cancels receiving a job when
the printer cannot detect the end of the job. If you select Use Machine Setting(s), enter a value
between 0 to 999. (Default: 300)
Default: [Use Driver/Command]
• Use Driver/Command
• Use Machine Setting(s)
Data Format
Select the data format from Binary Data or TBCP.
This setting is ineffective when using a parallel or EtherTalk connection.
When using a parallel or USB connection, the print job is canceled if binary data is sent from
the printer driver.
4. Making Printer Settings Using the Control Panel
116
To Next Page
Loading...
Need help?
General