Setting Description Setting Value
Phase 2 Authentication
Algorithm
Specify the authentication
algorithm to be used in phase
2.
(auto setting)
• HMAC-MD5-96
• HMAC-SHA1-96
Phase 2 Encryption Algorithm
Permissions
Specify the encryption
algorithm to be used in phase
2.
(auto setting)
• Cleartext (NULL
encryption)
•
DES
• 3DES
• AES-128
• AES-192
• AES-256
Phase 2 PFS
Specify whether to activate
PFS. Then, if PFS is activated,
select
the Diffie-Hellman group.
(auto setting)
• Inactive
•
1
• 2
• 14
Phase 2 Validity Period
Specify the time period for
which the SA settings in phase
2 are valid.
Specify a period (in seconds)
from 300 (5min.) to 172800
(48 hrs.).
Encryption Key Manual Settings Items
Setting Description Setting Value
Address Type
Specify the address type for
which IPsec transmission is
used.
• Inactive
•
IPv4
• IPv6
• IPv4/IPv6 (Default
Settings only)
Local Address
Specify the printer's address. If
you are using multiple IPv6
addresses, you can also
specify an address range.
The printer's IPv4 or IPv6
address.
If
you are not setting an address
range, enter 32 after an IPv4
address, or enter 128 after an
IPv6 address.
7. Enhanced Network Security
110
To Next Page
Loading...
