Parameter Value configured
keyphrase "phrase" val {1|2|3|4} You can specify the WEP key by entering in
ASCII.
With a 64-bit WEP, you can use 10 digit
hexadecimals. With a 128-bit WEP, you can use
26 digit hexadecimals.
Up to four WEP keys can be registered. Specify
the number to be registered with "val".
When a WEP is specified by key phrase, the
WEP specified by key is overwritten.
To use this function, set the same key number and
WEP key for all ports that transmit data to each
other.
You can omit the numbers with "val". The key
number is set to 1 when making these omissions.
encval {1|2|3|4} You can specify which of the four WEP keys is
used for packet encoding. "1" is set if a number
is not specified.
wepauth [open|shared] You can set an authorization mode when using
WEP.
The specified value and authorized mode
are as follows:
open: open system authorization (default)
shared: shared key authorization
security {none|wep|wpa} You can specify the security mode.
none: No encryption (default)
wep: WEP encryption
wpa: WPA encryption
wpaenc {tkip|ccmp} You can specify WPA encryption key when using
WPA encryption.
tkip: TKIP (default)
ccmp: CCMP (AES)
2. Remote Maintenance Using telnet
74
To Next Page
Loading...
Need help?
General