SP Mode Tables
D096 4-4 SM Appendix
1110*
Fan Control Timer
1110 1
[30 to 60 / 30 / 1 s/step]
Inputs the fan control time. The fan maintains normal speed for the specified
time after occurrence of an SC or following entry into Warm-up mode, Low
Power mode, or Night/Off mode.
1159*
Fusing Jam SC Code Setting
0=No 1=Yes
1159 1
This SP mode detects SC559. Set this SP mode to 'Yes' if the machine
experiences paper jam problems on a continual basis.
1902
Display-AC Freq.
1902 1
Displays the fusing lamp power control frequency (as detected by the zero
cross signal generator). The displayed value is 1/5 the actual frequency: 10 =
50 Hz, 12 = 60 Hz.
1903*
Feed Clutch Boost
Adjusts the amount of extra push that the feed clutch gives to the paper after
the skew has been corrected at registration. This feature helps the
registration roller feed certain types of paper (such as thick paper). Increase
the value if thick paper is jamming after feeding from the registration roller.
1903 1 By-pass tray
[0 to 10 / 6 / 1 mm/step]
1911*
By-pass Envelope
1911 1
[0 = Disabled / 1= Enabled
The program dedicated to envelope printing runs when you enable this
program (SP 1911 1) and you select "Thick Paper" as the paper type of the
by-pass tray (System Settings > Tray Paper Settings > Paper Type: By-pass
Tray).
To Next Page
Loading...
