SP Mode Tables
SM Appendix 4-9 D096
Appendix:
SP Mode
Tables
2906 2
Interval
[1 to 10 / 1 / 1 page/step]
Changes the interval for the image shift specified by SP 2906 1.
2908
Forced Toner Supply
2908 1
Forces the toner bottle to supply toner to the toner supply unit. Press "1" to
start. The machine continues to supply toner until the toner concentration in
the development unit reaches the standard level, or for up to 2 minutes
(whichever comes first).
2915*
Polygon Mirror Motor Idling Time
2915 1
[0 = None / 1 = 15 s / 2 = 25 s]
Selects the polygon mirror motor idling time. To increase the speed of the first
copy, the mirror motor begins idling when the user sets an original, touches a
key, or opens the platen cover or DF. If this setting is left at the default (15 s),
the motor will stop if the user does nothing for 15s. If the setting is "0", the
motor will not switch off during standby. (But note that regardless of the
setting, the motor will switch off when the machine enters energy saver
mode.)
2921*
Toner Supply Mode
2921 1
[0 = Sensor 1 / 1 = Sensor 2 (DFU) / 2 = Fixed 1 (DFU) / 3 = Fixed 2]
Selects the toner supply mode. Under normal conditions this should be set to
"0". You can temporarily change this to "3" if the TD sensor is defective. Do
not set to "1" or "2", as these are for design use only (
Toner Density
Control).
To Next Page
Loading...
