SP Mode Tables
SM Appendix 4-11 D096
Appendix:
SP Mode
Tables
2927*
ID Sensor Control
2927 1
[0 = No / 1 = Yes]
Selects whether the ID sensor is or is not used for toner density control. This
value should normally be left at "1". If the value is "0", dirty background may
occur after long periods of non-use.
2928
Toner End Clear
2928 1
Clears the toner end condition without adding new toner. The following are
cleared:
Toner end indicator (goes out)
Toner near-end counter
Toner near-end level
This function should generally not be used. If you clear the toner end
condition without adding new toner, there is a risk that the drum may
eventually begin to attract carrier after many more copies are made and toner
runs out. This attracted carrier may damage the drum.
2929*
Vref Limits
Adjust the upper or lower Vref limit.
2929 1 Upper
[0.50 to 3.50 / 3.20 / 0.01V/step] DFU
2929 2 Lower
[0.50 to 3.50 / 0.70 / 0.01V/step] DFU
2994*
ID Sensor Detection
Temperature
[30 to 90 / 30 / 1 °C/step]
2994 1
While the machine is recovering from an energy saver mode, or while the
machine starts, the BICU ignores the ID-sensor signals if the fusing
temperature is at the specified value or higher.
To Next Page
Loading...
