Copier Installation
D096 2-6 SM
3. Open the right door [B], and remove the PCU (photoconductor unit) [C].
4. Separate the PCU into the upper part and the lower part (
x 5).
5. Put a sheet of paper on a level surface and place the upper part on it.
This prevents foreign material from getting on the sleeve rollers
6. Distribute a pack of developer [D] to all openings equally.
Do not spill the developer on the gears [E]. If you have spilled it, remove the
developer by using a magnet or magnetized screwdriver.
Do not turn the gear [E] too much. The developer may spill.
To Next Page
Loading...
