- / / / is the channel key. Depending on the actual
situation, press the k
ey to enable (display), select, or disable the corresponding
channel, as described below:
- If the channel is not displayed, you can press the channel key to open the
channel in the waveform view window.
- If the channel is displayed but not selected, you can press the channel key to
select the channel.
- If the channel is both displayed and selected, you can press the channel key
to close its display in the waveform view.
For two-channel models (DHO1072/DHO1102/DHO1202), only two channel
keys (
and ) are available.
11. Hor
izontal Controls
- Horizontal POSITION is the horizontal position knob. Tur
n the knob to
change the horizontal position (trigger position) to move the waveforms
horizontally. Press the knob to reset the horizontal position to default.
- Horizontal
SCALE is the horizontal scale knob. Tur
n the knob to change the
horizontal time/div setting to compress or expand waveforms of all channels
horizontally. Press this knob to toggle between fine and coarse adjustment of
the horizontal scale.
-
is the acquisition setup key. Press this key to access the Horizontal menu.
Y
ou can set the oscilloscope
's time base mode, acquisition mode, memory
depth, etc.
Quick Start
DHO1000 User Guide
22
Copyright ©RIGOL TECHNOLOGIES CO., LTD. All rights reserved.
www.calcert.com sales@calcert.com1.888.610.7664
0
5
10
15
20
25
30
To Next Page
Loading...
Need help?
General
