Recalling Data Sets R&S ESCI
1166.6004.12 4.246 E-1
The SEL ITEMS TO SAVE/RCL softkey opens a submenu for selecting the data subsets.
FILE - ITEMS TO SAVE/RCL submenu:
ITEMS TO
SAVE/RCL
The Dialog SaveL table offers the following selectable data subsets in the Items field:
Current Settings These settings include:
• current configuration of general instrument parameters
• current measurement hardware settings
• active limit lines:
A data set may contain maximum 8 limit lines for each
window. It always contain the activated limit lines and the
de-activated limit lines used last, if any.
Consequently, the combination of the restored
de-activated limit lines depends on the sequence of use
with command MMEM:LOAD.
• the activated transducer factor
• user-defined colour settings
• configuration for hardcopy output
• active transducer:
A data set may contain maximum 4 transducer factors. It
always contain the activated factors and the factors used
and de-activated last, if any. Consequently, the
combination of the restored de-activated transducer
factors depends on the sequence of use with the
command MMEM:LOAD.
• peak list or final measurement results (receiver mode)
• settings of tracking generator (only with option tracking
generator)
• settings of tracking generator (only with option)
All Limit Lines all limit lines
All Transducers all transducer
All Traces all traces which are not blanked
Source Cal Data correction data for tracking generator (only with options B9 /
B10)
To Next Page
Loading...
