Rohde & Schwarz ESW Series - Page 116

Measurements and Result Displays
R&S
®
ESW
116User Manual 1177.6298.02 ─ 08
Changing channels while a scan is running
When you change the measurement channel while a scan is running (for example
switch to a spectrum channel), the R&S ESW holds the scan. When you change back
to the receiver channel in which the scan is running, you can resume the scan from the
hold frequency.
9.3.3.3 Configuring the Scan Table
Access: "Overview" > "Test Automation" > "Scan Table"
By default, the scan table already contains two scan ranges with a typical configuration
for these frequency ranges.
Figure 9-10: Overview of the "Scan Table"
The remote commands required to design a scan table are described in
Chap-
ter 15.5.6, "Scan Table Configuration", on page 454.
Functions in the "Scan Table" dialog box described elsewhere:
●
Scan Type
●
Filter Type
Adding and removing scan ranges..............................................................................117
Defining a frequency range for the scan..................................................................... 117
Adjusting the frequency axis........................................................................................117
Selecting the frequency step mode............................................................................. 118
Displaying range bars..................................................................................................118
Configuring scan ranges..............................................................................................118
└ Range Start and Range Stop........................................................................119
└ Step Size.......................................................................................................119
└ Measurement Bandwidth.............................................................................. 119
└ Measurement Time....................................................................................... 120
└ Auto Range...................................................................................................120
└ Attenuation....................................................................................................121
└ Preamplifier...................................................................................................121
└ Input Selection.............................................................................................. 122
Test Automation