Rohde & Schwarz ESW Series - System Configuration Settings; Hardware Information

General Instrument Setup
R&S
®
ESW
334User Manual 1177.6298.02 ─ 08
Remote command:
[SENSe:]ROSCillator:O640 on page 622
[SENSe:]ROSCillator:OSYNc on page 623
Resetting the Default Values
The values for the "Tuning Range", "Frequency" and "Loop Bandwidth" are stored for
each source of "Reference Frequency Input".
When you switch the input source, the previously defined settings are restored. You
can restore the default values for all input sources using the "Preset Channel" function.
13.5 System Configuration Settings
Access: [Setup] > "System Configuration"
● Hardware Information............................................................................................334
● Information on Versions and Options....................................................................335
● System Messages.................................................................................................336
● Firmware Updates.................................................................................................337
● General Configuration Settings.............................................................................338
13.5.1 Hardware Information
Access: [Setup] > "System Configuration" > "Hardware Info"
An overview of the installed hardware in your R&S ESW is provided.
Every listed component is described by its serial number, order number, model infor-
mation, hardware code, and hardware revision.
This information can be useful when problems occur with the instrument and you
require support from Rohde & Schwarz.
Remote command:
DIAGnostic:SERVice:HWINfo? on page 668
System Configuration Settings