Rohde & Schwarz ESW Series - Network and Remote Control Settings; General Network Settings

Network and Remote Operation
R&S
®
ESW
398User Manual 1177.6298.02 ─ 08
You can also copy the program to any Windows PC or laptop. Simply copy the
iecwin32.exe, iecwin.chm and rsib32.dll files from the location above to the
same folder on the target computer.
When the tool is started, a "Connection settings" dialog box is displayed. Define the
connection from the computer the IECWIN tool is installed on to the R&S ESW you
want to control. If you are using the tool directly on the R&S ESW, you can use an NT
Pipe (COM Parser) connection, which requires no further configuration. For help on
setting up other connection types, check the tool's online help (by clicking the "Help"
button in the dialog box).
The IECWIN offers an online help with extensive information on how to work with the
tool.
14.4 Network and Remote Control Settings
Access: [SETUP] > "Network + Remote"
Network settings in secure user mode
Be sure to store all network settings beforeSecureUser Mode is enabled; see Chap-
ter 4.7, "Protecting Data Using the Secure User Mode", on page 40.
If the currently stored network settings are not suitable, you must correct them each
time you switch on the R&S ESW in secure user mode, as the settings are not stored
permanently in this case.
The remote commands required to define these settings are described in Chap-
ter 15.9.7, "Network and Remote Control Configuration", on page 660.
Step-by-step instructions are provided in Chapter 14.5, "How to Set Up a Network and
Remote Control", on page 409.
● General Network Settings..................................................................................... 398
● GPIB Settings........................................................................................................400
● Compatibility Settings............................................................................................403
● LXI Settings...........................................................................................................405
● Remote Errors.......................................................................................................407
● Returning to Manual Mode ("Local")..................................................................... 408
14.4.1 General Network Settings
Access: [SETUP] > "Network + Remote" > "Network" tab
The R&S ESW can be operated in a local area network (LAN), for example to control
the instrument from a remote PC or use a network printer.
Network and Remote Control Settings